UID23171
阅读权限1
经验822
胶卷0
相册0
日志0
记录0
分享0
性别保密
个人主页
游客
精华
帖子343
注册时间2008-12-31
在线时间633 小时
最后登录2014-5-20
好友0
|
http://www.rangefinderforum.com/ ... p;highlight=Jupiter
找到参考资料了 有个叫Brian Sweeney说J3和J8都是按照蔡司标准造的 如果要在莱卡上用的话 有个地方要弄个10丝的垫片。。。有大侠会弄么?
These are not hard lenses to work on. The Jupiter-3 and Jupiter-8 are built to the Zeiss standard, and typically need 0.1mm added to the shim for use on a Leica. The worst part is re-aligning the aperture ring, need to tap out 3 little holes.
Same with a Lube job: three set screws for the focus ring, 3 for the helical and only 1 for the KMZ mount, two guide pins to separate the inner and outer helical. The worst part is getting the old Lube off. Ronsonol to the Rescue! |
|